Ella EW-SS-A-STD Przewodnik Instalacji Pobierz pdf (Strona 11)

www.ellasbubbles.com Page 11 08/14

www.bciacrylic.com

Step 10: Measure and mark the length of the liner, using the width line as a starting point. Use a straight edge to extend the line.

Step 11: Measure and mark the height of the threshold in 3 or 4 different locations. Connect the markings with a straight edge.

(Image NN)

Step 12: Using an orbital jigsaw, carefully cut the liner, supporting the liner with your other hand and keeping your ngers away from the blade.

Step 13: Test t the liner and trim as necessary. Now is the time to check the t to the existing pan and see if you will need additional layers of tape.

NN OO

Step 14: Install the liner by placing butyl primer along the bottom of the acrylic liner, keeping away from the drain area and the rail of the threshold.

(Image OO) Then, prime the rail and the bottom of the existing base, again keeping away from the drain area. (Image PP)

Step 15: Place at tape on top of the primer, setting it paper to paper. Layer the tape as needed to ensure proper contact. Pull the release paper and

double-up tape along the perimeter. Remove the release paper.

(Image QQ)

Step 16: Place round tape along the shelf of the existing base 1/2” away from the wall. (Image RR) Remove the release paper. Place a continuous bead of

silicone around the perimeter between the round tape and the wall, and around the drain of the existing base.

(Image SS)

Step 17: Insert the pan liner, then walk up and down the perimeter to ensure proper contact. Wipe off any excess silicone.

Step 18: Install the new drain. Refer to page 22 for proper instructions.

Step 19: Once drain is installed, use silicone primer along the perimeter of the pan liner, followed by a color-matching silicone.

Tip:

If you intend to use a turn-buckle or crossbar drain on a at pan liner, you will need to install the adapter plate before you begin to install

the liner. If your pan liner has a dimpled recess, you can install the adapter plate after the liner is installed.

Tip:

It is okay if there is a tiny gap between the pan liner and existing walls. The walls can be built out to cover the gap.

QQ RR SS

INSTALLATION / SHOWERLINERS & SHOWER BASES

PAN LINER INSTALLATION

CONTINUED

SHOWER LINER INSTALLATION (CONTINUED)

Shower Bases

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 47 48

Komentarze do niniejszej Instrukcji

Brak uwag

Ella EW-SS-A-STD Przewodnik Instalacji Strona 11

Komentarze do niniejszej Instrukcji