Ella EW-SS-A-STD Przewodnik Instalacji Pobierz pdf (Strona 10)

www.ellasbubbles.com Page 10 08/14

www.bciacrylic.com

TOOLS

o Pipe Wrench

o Hammer or Sledge

o Pry Bar

o Spud Wrench

o Sharpie® Marker

o Notepad

o Tape Measure

o Drop Cloths

o Utility Knife

Step 1: Remove all hardware, including the drain cover. (Image HH)

Step 2: Stuff a rag into the drain to keep debris from entering.

Step 3: Measure the drain center, from the soap dish wall to the center of the drain and again from the plumbing wall to the center of the drain. Record the

measurements.

(Image II)

Step 4: Use the small wall template to get the angles of the existing shower. Place the template in the corner of the existing base, with one end against the

soap dish wall and the other end against the plumbing wall. Set the template to t and tighten the lock knobs. (Image JJ)

INSTALLATION / SHOWERLINERS & SHOWER BASES

HH II JJ

Step 5: Carefully remove the template from the shower base. Do not bump the template. If you do, you will need to go back and re-template.

Step 6: Measure the height of the threshold by holding a straight edge out from the top of the rail, measure from the oor to the straight edge in 3 or 4

locations.

(Image KK)

Step 7: Add

” to your height measurements for thickness of acrylic material and adhesives. Record the measurements.

Step 8: Transfer measurements. To mark the drain center, place a straight edge in the drain area. Measure from the drain center to the soap dish wall and

mark your measurements. Then measure from the drain center to the plumbing wall and mark your measurement. (Image LL)

Step 9: Place the template along the marks, and trace the outside of the template. (Image MM)

KK LL

INSTALLATION / SHOWERLINERS & SHOWER BASES

PAN LINER INSTALLATION

SHOWER PAN INSTALLATION

Shower Bases

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 47 48

Komentarze do niniejszej Instrukcji

Brak uwag

Ella EW-SS-A-STD Przewodnik Instalacji Strona 10

Komentarze do niniejszej Instrukcji